CUTTING MACHINE MOD.
–
S26
–
S32
–
S36
–
S40
–
S45
–
S50
–
S55
Operating, maintenance, spare parts manual Rel. 3 dated 02/07/2019
Pagina 30 di 54
8. MAINTENANCE
The machine does not require any particular maintenance work. The technical solutions and the components
installed on the machine reduce maintenance at the minimum. However, we recommend to carry out a series of
operations, which aim at ensuring safety, liability, efficiency and long life of the machine.
Duing maintenance
Before performing any maintenance work on the machine, disconnect the power cable from
the machine
. In case of mechanical or electric trouble, call the authorized personnel. If the machine
is out of service because of trouble, maintenance or repair, place a special sign highlighting this status so as to avoid
accidental starting.
Always use the personal protective equipment (leather gloves of approved type, safety shoes, safety mask and safety
goggles) during repair and replacement of the machine elements.
Repairs of the electric installation shall be done by authorized and specialized personnel only.
Do not approach hands, arms or other parts of your body to the movement and transmission area. Use appropriate means
(brush, wooden piece, etc.) to remove possible rubble:
never use your hands!
To ensure long life, prevent damage and ensure the full functioning of the mechanical and electric machine elements the
maintenance must be performed regularly. Periodically check the earthing system, according to the laws in force.
Before starting the machine, ensure there are no tools or foreign matters left inside or on the machine.
8.1 Recommended lubricants
MINERAL OIL
23°E at 50°C
–
320cSt at 40°C 32°E at 50°C
–
450cSt at 50°C AGIP
HYDRAULIC SYSTEM
OSO 68
/
ISO
–
VG 68/460 TYPE
GREASE
LUBRIC. AND
VARIOUS GEARS
MAKE
TYPE
PENETR.
DRIP
1
st
LUBRIC.
FOLL.LUBR.
ESSO
BEACON EP 2
265/295
8.2 Ordinary Maintenance
-
To be carried out every day at the end of the work.
- To be carried out every weeK at the end of the work.
A) DAILY CLEANING AND MAINTENANCE
Stop the cutting machine and cut off the electric energy supply, then remove material residuals and deposits from: the cutting
area
Caution!! Do not wash with high-pressure water jets.
B) WEEKLY CLEANING AND MAINTENANCE
At the end of the week, after the cleaning of the cutting machine as explained above, provide for:
Check tightening of clamping screws of main moving parts.
Lubricate all the parts, which are not protected by means of painting.
Check the oil level inside the tank through the pilot lamp placed on the rear side of the machine.
Check the safety of the electric system: cable isolation, differential protection device, earthing conductor continuity,
operation of safety switch of cutting area protection.
Check the interlocks of the different mechanical components.
Respect the lubricant replacement frequency (at least every two years), as stated in the lubrication table.
Oil is a special waste and must be disposed of according to the laws in force.
IMPORTANT :
Los controles diarios y semanales son muy importantes también a nivel de prevención de las averías.
Daily and weekly checks are very important to prevent machine troubles. In fact, whenever during these checks
you will find some worn or damaged components, immediately order the relevant spare parts to be kept on stock,
before the component has definitively broken with consequent production stop
.
8.3 Extraordinary maintenance
- Check the safety of the electric system: isolation of cables, working of differential
protection device, continuity of protection wire, working of safety limit switch on guards. - Check interlocks of mechanical
components - Change the lubricants according to the lubrication schedule.
Note**The bushing, the electric motors and all other consumables must be immediately replaced whenever a running defect
occurs.
