Si4700/01/02/03-EVB
Confidential Rev. 0.6
9
5. Hardware Setup
The EVB is connected to a PC, which is running the associated software, as shown in Figure 4.
Figure 4. Hardware Setup
1. Connect a SMA cable to the SMA connector J1 on the daughter card and apply the desired FM input.
2. Connect one end of a BNC cable to the BNC connector J10 on the baseboard. Connect the other end of the BNC cable to
an audio analyzer, amplifier, or other test equipment with an input impedance > 10 k
Ω
.
3. Connect one end of a BNC cable to the BNC connector J11 on the baseboard. Connect the other end of the BNC cable to an
audio analyzer, amplifier, or other test equipment with an input impedance > 10 k
Ω
.
4. Make sure SW1 is set for USB POWER.
5. Connect the appropriate end of the USB cable to the USB connector J1 on the baseboard.
6. Connect the other end of the USB cable to a USB port on the PC.
PC with USB
Port
RF Generator
Si470x FM Tuner RF
Board
Si470x FM Tuner
Baseboard
USB
Power
Connector
Headphone
Jack
Audio Anaylzer
Rout Lout
CH1
CH2
FMIP
EXT CLK
J4
EVB (as viewed
in Figures 1 & 2)
J1
J1
J3
J11
J10
BNC
Cable
SMA
Cable
J7
Power
Jack
SW1
USB POWER
EXT POWER
Summary of Contents for Si4700-EVB
