8
Installation Instructions - Intergrated Application
Preparing the
Enclosure
FOR YOUR SAFETY:
While performing
installations described in
this section, gloves, safety
glasses or goggles should
be worn.
Tools You Will
Need
Electrical Requirements:
The appliance must be
connected to an individual
properly grounded electrical
outlet, protected by a 15 or
20 ampere circuit breaker or
time delay fuse.
It is recommended that you do
not install the beverage center
into a corner (i.e. directly beside
a wall). This is to allow the
door(s) to have a greater then
90° opening swing. A limited
door swing will prevent the
shelves from sliding out as
intended, and may lead to dam-
aging the door gasket(s).
The rough cabinet opening
must be on a level floor area
and at least 25” deep by 24”
wide. The opening should also
have a height of at least 34-9/16”.
The electrical outlet may be
positioned from within either
side of the adjacent cabinetry, or
the rear of the shaded area (as
shown in Fig D.).
If the electrical outlet is located
inside the adjacent cabinetry, cut
a 1-1/2” diameter hole to admit
the power cord. If the cabinet
wall is metal, the hole edge
must be covered with a bushing
or grommet.
Electrical Access
Cabinets
Square
and
Plumb
35”
From
Floor
24”
6”
1-1/2” dia. hole
*if electical outlet
is in adjacent
cabinetry
D
1 1/2” diam. hole
* If electrical out-
let is in adjacent
cabinetry.
34-9/16” from
underside
of
countertop
to floor
Cabinets
square
and
plumb
Fig D
25”
24”
1-3/16”
Fig.E
NOTE:
This unit is front breathing.
Do not block the front air vent. Blockage
of the vent will result in high operating
temperatures and system failure.
(Fig.E)
