6
Operating Instructions
Setting the
Temperature
When you plug in your beve
r-
age center for the first time,
the temperatures will auto-
matically be set to 54
°
F
(12
°
C) and will be displayed
in the Fahrenheit scale (
°
F).
To switch the display
between the Fahrenheit (
°
F)
and Celsius (
°
C) scale,
depress the and
control buttons simultaneously
for approximately 3 seconds.
The temperature range can
be set as low as 36
°
F (2
°
C)
or as high as 64
°
F (18
°
C) to
suit your specific storage
requirements. Each depres-
sion of the or but-
ton will allow you to
adjust
the
temperature in 1
°
degree
increments within the afore-
mentioned range.
The Controls of your
Beverage Center
1.
Indicator light illuminates to signify the
cooling mode is currently in operation.
2. ‘ ’ Button
To control this appliance turn ON/OFF
( press and hold this buttons for
approximately 3 seconds).
3. ‘ ’ Button
To control the inner light turn ON/OFF.
(If press this botton,the inner light is
not controled by The reed swith
and keep lighting.)
4. °C / °F
Adjacent indicator light denotes which
scale of temperature is displayed.
5. ‘
’
Button
Used to raise (warmer) the temperature
in 1° degree increments.
‘
’
Button
Used to decrease (cooler) the
temperature in 1° degree increments.
Function
Instructions
NOTE !
°
°
If too many bottles/cans are put in at
once or the door has not been
closed tightly, the unit will display the
is normal please wait 5 minutes
after you close the door and
“HI” will disappear.
It is normal that the cabinet
shows “HI” or “LO” from time to time,
If it occurs frequently or lasts for a
long time, you can restart the unit by
unplugging it. If the problem
occurs once again after restart,
please contact the customer service.
"HI" signal in the display panel. This
Temperature Memory Function
Door Ajar Alarm Function
Temperature Alarm Function
If the inner temperature is higher than 73°F(23°C), “HI” is shown
in the display panel, or if and the alarm will sound after one hour.
If the inner temperature is lower than 32°F(0°C),“LO” is shown in
the display panel and the alarm will sound. Refer to the trouble
shooting guide on page 11 for more information.
In the event of a power interruption the beverage center can
remember the previous temperature settings, and when the
power is restored the cabinet temperature will go back to the
same setting as before.
If the door is not closed completely the alarm will sound after
5 minutes. Close the door completely to avoid the loss of cold air.
