SILENT KNIGHT SK-2224, Installation And Operation Manual

Page: 38 / 62

System Operation
151165 6-3
6.2 Operation Keys (Switches)
All system operations are performed from the on-board keys (switches) as described in the
chart below.
Table 6-2: Operations and Instructions
Operation Keystrokes
Disable notification appliance circuit.
To re-enable the circuit, press [NAC
DISABLE] again.
Press the appropriate [NAC DISABLE] key. The NAC circuit will be disabled and
the corresponding TROUBLE LED will Double Flash. This function is not available
during an alarm condition.
Disable a zone
To re-enable the circuit, press [ZONE
DISABLE] again.
Press the appropriate [ZONE DISABLE] key. The zone will be disabled and the
corresponding TROUBLE LED will Double Flash. This function is not available
during an alarm or supervisory condition.
Begin Walk Test Press [WALK TEST]. Walk Test LED turns on.
Note:
Walk test will not activate if the control panel has a trouble, alarm,
or supervisory condition.
End Walk Test
(The test ends automatically after 10
minutes of no system activity.)
Press [WALK TEST].
NOTE: The Walk Test feature is not operational during an alarm, supervisory or any
system trouble condition.
Acknowledge condition (alarm,
supervisory, trouble) Press [ACK]. The corresponding LED will change from blinking to steady for the
duration of the condition.
Silence Panel Press [SILENCE]. This will silence the on-board PZT and all active NAC circuits
that have been configured as "silenceable".
Perform system reset Press [RESET]. Resets alarms, supervisories, troubles and all LEDs.