3 Year Warranty
Your new Silencer
®
Security Systems is warranted to be free of defects for 3 years. Silencer
®
or its
authorized agents will within 3 years from the date of sale to you, repair or replace said product or
any part thereof, at the option of the Silencer
®
or its authorized agents, if said product or part is
found defective in materials or workmanship, when properly connected and operating on the correct
power requirements designated for the specific product. This warranty and Silencer
®
or its
authorized agents obligations hereunder do not apply where the product was; damaged while in the
possession of the consumer, subjected to unreasonable or unintended use, not reasonably
maintained, or serviced by anyone other than Silencer
®
or its authorized agents, or where the
warning seal on the product is broken or the power and/or plugs are detached from the unit. This
warranty does not cover the cabinet appearance items or accessories used in connection with this
product, or any damage to the products resulting from improper installation, alteration, accident,
misuse, abuse or acts of nature. Silencer
®
OR ITS AUTHORIZED AGENTS SHALL NOT BE LIABLE
TO ANYONE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES OR CLAIMS EXCEPT THOSE
ACCORDED BY LAW. NO EXPRESSED WARRANTY OR IMPLIED WARRANTY IS GIVEN EXCEPT
THOSE SET FORTH HEREIN. NO IMPLIED WARRANTY SHALL EXTEND BEYOND 3 YEARS FROM
THE DATE OF SALE. Some states do not allow limitations on how long an implied warranty lasts, and
some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusion may not apply to you. This warranty gives you specific legal rights,
and you may have other rights that vary from state to state. Defective merchandise should be
returned to the original point of purchase or secondly, to 1111 W. Victoria Street, Compton CA
90220. Return Authorization must be obtained before sending, or merchandise may be refused. All
claims concerning your Silencer
®
Security System should be referred to your selling dealer. If you
are away from the vicinity of the selling dealer please call (800) 340-3200.
© 2004 Copyright Magnadyne Corp.
To replace (or remove for storage) the batteries in your transmitter, follow this procedure:
1. Turn the transmitter over and locate the slot at the edge of the transmitter case.
2. Use a small flathead screwdriver to pry apart the top and bottom case of the transmitter while
keeping the button side facing downward.
3. Once the back is completely removed, press on the button face to remove the entire transmitter
assembly from the case.
4. Separate the transmitter circuit board from the rubber button case and slide the old battery out
of it’s holder.
5. Replace the battery in reverse sequence observing the correct polarity of the battery (+ battery
side should be facing upward).
6. The 3 volt battery for this transmitter is model CR2032. This battery is very common and can be
found in most convenience stores and camera shops.
Battery Replacement
4900UM
3-2-04 Rev. B
4900UM 3/2/04 12:59 PM Page 4
