7.2
Replacing the cutting tool
To replace a worn cutting tool, proceed as follows:
ATTENTION: remove the mains plug.
1) Slot the locking rod (provided) into the hole of the cutting tool shaft (Fig. 32).
2) Use the spanner provided to loosen the cutting tool locking nut (L1) (Fig. 33).
ATTENTION: the thread is left-handed.
1)
Remove the worn cutting tool.
2)
Carefully clean the new cutting tool and its seat.
3) Install the new cutting tool (pay attention to the rotation direction) and tighten the nut (L1) anticlockwiese.
4)
Remove the locking rod.
5) Check calibration (chap.5.2).
L1
LOOSEN
TIGHTEN
Fig. 32
Fig. 33
Operating manual
REKORD PRO d-12
Copyright Silca S.p.A 2022
22
