Silca Bravo Maxima II, Operating Manual

Page: 29 / 42

Operating manual - English BRAVO MAXIMA II
Copyright Silca 2011 25
7.9 Replacing the condenser (motor) and/or feeder (lamp)
1) Remove the bottom panel (see ch. 7.7).
CONDENSER
1) Loosen the nut (Z) and remove the washer (Z1) and condenser (fig.33).
2) Fit the new condenser and fix with the washer (Z1) and nut (Z).
3) Remove the cap (Z2) from the new condenser.
4) Remove the cap from the old condenser and detach the connectors (1 and 2) from the old
condenser to connect them to the new one, paying attention to their positions.
5) Replace the cap (Z2) on the new condenser.
6) Replace the bottom safety plate, fix with the 7 screws (W) and 2 feet (fig. 31, page 24). Fit the
swarf tray.
LAMP REACTOR
1) Loosen the 2 screws (Y) and remove the reactor (fig.34).
2) Use the tip of a small screwdriver to enter the slits (Y1) and detach the 2 wires (Y2), (Y3).
3) Fit the 2 wires (Y2), (Y3) into the special connections on the new reactor.
4) Place the new reactor in its seat and secure with the 2 screws (Y).
5) Replace the bottom safety plate and fix with the 7 screws (W) and 2 feet (W1) (fig. 31, page 24). Fit
the swarf tray.
Fig. 33
Fig. 34
Z1
Z
Z2
Z2
1
2
Y
Y1
Y2
Y3