EH-5500FD Installation Manual
Page 39
o
Static – Fixed modulation profile. If you select Static, you must select from a
list of pre–configured modulation profiles in the Modulation field.
o
Adaptive – Adaptive Bandwidth, Code, and Modulation.
The ODU will work on the highest modulation profile based on the CINR
values of the both sides and will present the current modulation profile.
Adaptive mode is the normal and recommended mode of the radio link.
Alignment Status – R/O field, indicating that the ODU is currently in Alignment
mode (by configuration or by inserting DVM probes).
Click
Next
to continue or
Back
to return to previous section.
3.4.3
Quick Configuration: Step 3
– Eth Ports
Figure 3-7 Quick Config Page: Step 3
– Eth Ports
This section allows configuring the following parameters:
Port status visual display (Green – port is up).
Port Type – RJ45 or SFP
Port Enable – checkbox to enable the port.
Auto Negotiation – checkbox to enable auto-neg.
Speed/Duplex – speed (10/100 or 1000) and duplex (half/full) setting:
o
When Auto Negotiation Enabled – R/O field indicating the current
speed/duplex
o
When Auto Negotiation Disabled – allows configuring the speed/duplex.
Note:
When exiting Alignment mode, perform system reboot to allow proper operation of
the radio link.
