ba_tp18600e_e.doc/03/04/e
Version 0.2
Page 2
1 Description of the temperature calibrator TP 18 600 E
The test instrument TP 18600E consists of two single
enclosures, front size 144 x 144 mm and depth
340 mm or 390 mm. They are connected with each other
and equipped with a portable handle.
The left enclosure contains a brass block with a bore,
diameter 18 mm (28 mm) and depth 100 mm
(200 mm), which can be reached from the top, for the
reception of the test piece. In this block the heating
cartridge and the temperature sensor for the
determination of the block temperature are installed
accessible from the bottom.
The right enclosure contains the controller for control of
the block temperature. A Solid state relais is used for the
activation of the heating catridge.
On the front plate ist the controller, a switch for mains
power and also a switch for fan. The controller is
equipped with a 2-line, 4-digit, 7-segment LED for block
temperature and set value.
On the right hand side of the instrument combination the
IEC chassis mounting plug for the mains connection is
available. Besides the mains power cable the fuse holder
is located.
2 Safty instructions
The temperature calibrators of series TP 18.600 E correspond to the current state of technology. This refers to
measuring accuracy, function as well as safe operation of the devices. To grant safe operation, competent and
responsible behaviour of the operator is essential.
Fundamental safety regulation and operators duty of care
•
Operate the equipment only in perfect functional conditions
•
The national rules of safety and prevention of accidents have to be carefully observed as well as the
following safety notes of this manual.
•
The equipment is supplied via mains cables with a tension dangerous for humans.
Person injuries can arise by inappropriate use.
•
The perfect and safe operation of this equipment requires appropiate transport, professional storage,
installation, assembly and use as directed, as well as careful operation and maintenance.
•
The equipment must only be used as directed. Furthermore dangerous media must not be used and all
specifications have to be kept.
•
If disturbances can not be eliminated the equipment immediately is to be set out of operation and to be
protected from inadvertent start-up.
•
Only the manufacturer is permitted to carry out repair works. Interferences or changes at the equipment
are inadmissible.
•
Before exchanging the fuse, the equipment is to be seperated from the mains supply by pulling the cable
from the mains plug.
•
Make this manual always availabe in a legible and complete form in situ of the equipment.
