8
5. Press Enter to continue and follow on-screen instructions to
complete Windows XP installation.
Note:
When the Software Installation warning pops up, click
Yes
. And when the Hardware Installation warning pops up,
click Yes again.
For Existing Windows XP Installation
Important:
If the hard disk drive connected to your controller has a boot
partition, do not connect this drive until the driver for the controller has
been completely installed in Windows XP. Follow the instructions below
to install the driver for the controller first, shut down your system and
connect the hard disk drive. The controller is now ready for operation.
1. Install the board and boot up Windows XP.
2. At the Found New Hardware Wizard, insert the driver
diskette, select Install the software automatically
(Recommended)
, then click Next.
3. At the next window, choose the entry with A:\si680.inf under
heading location. (This should be the first entry)
4. When a warning message pops up, click Continue Anyway,
then click Finish.
5. Remove the driver diskette and restart Windows to complete
driver installation.
Verify Proper Installation for Windows 2000/XP
1. Right click My Computer and click Manage.
2. Select Device Manager.
3. Double click IDE ATA/ATAPI Controllers, then double click
SiI 0680 ATA/133 Controller
to display driver properties.
4. A message This device is working properly is displayed in the
dialog box, the driver has been correctly installed.
Bios Configuration
The UltraATA 133 PCI BIOS will appear everytime your system
starts up. If the bios doesn't show, please try your controller in
another PCI slot. During this (Post) process, the bios will show up
and indicate the devices attached to it.
