7
Windows 2000 Driver Installation
For New Windows 2000 Installation
1. Install the board and follow Microsoft procedures to install
Windows 2000 accordingly.
2. At the Windows 2000 Setup screen, press F6 to install the
driver.
3. Insert the driver diskette. Press S, then press Enter.
4. Select SiI 0680 ATA/133 Controller for Windows 2000/XP and
press Enter.
5. Press Enter to continue and follow on-screen instructions to
complete installation.
For Existing Windows 2000 Installation
1. Install the board and boot up Windows 2000.
2. At the Found New Hardware Wizard, click Next.
3. Select Search for a suitable driver for my device
(recommended)
and click Next.
4. Insert the driver diskette, check Floppy disk drives, uncheck
the other boxes, and click Next. Click Next again to continue.
5. If the Digital Signature Not Found message appears, click
Yes
.
Note
If prompted for Windows 2000 CD-ROM, insert the CD
and click OK. Type in D:\I386, click OK and Finish. (assuming
D:
is your CD-ROM drive)
6. Click Finish, remove the driver diskette and restart Windows
to complete driver installation.
Windows XP Driver Installation
For New Windows XP Installation
1. Install the board and follow Microsoft procedures to install
Windows XP accordingly.
2. At the Windows Setup screen, press F6 to install the driver.
3. Insert the driver diskette. Press S then press Enter.
4. Select SiI 0680 ATA/133 Controller for Windows 2000/XP and
press Enter.
