14
64-bit Windows XP/Server 2003
For A New Installation
A new installation of Windows XP/Server 2003 requires
a floppy disk for the driver installation. To make this
floppy disk, copy the
contents
of the
64bit
folder, found
on the driver CD, onto a blank floppy disk then follow the
directions below.
1.
Setup the RAID array prior to Windows installation.
2.
Follow Microsoft procedure to install Windows
accordingly.
3.
Restart your system when prompted during
Windows' installation.
4.
At the
Windows Setup
screen, press
F6
to continue.
5.
Insert the driver
diskette. Press
S
then press
Enter
.
6.
Select
Silicon Image SiI... Controller (64-bit
Extended)
and press
Enter
.
7.
Press
Enter
to continue and follow on-screen
instructions to complete the installation.
When Windows installation completes, go to
SATARaid
GUI
on page 17 and install the RAID monitoring utility.
For An Existing Installation
1.
Install the board and boot up Windows.
2.
At the
Found New Hardware Wizard
:
For XP (w/SP1 or earlier)/Server 2003
: go to step #3.
For XP (w/SP2 or later)/Server 2003 (w/ SP1 or later)
:
select
No, not this time
, then click
Next
.
3.
Insert the driver CD, select
Install the software
automatically (Recommended)
, then click
Next
.
Note:
Most systems will install the driver
automatically after inserting driver CD.
Summary of Contents for Serial ATA PCI RAID
Page 34: ...34 Blank Page ...
