12
4.
At the
Windows 2000 Setup
screen, press
F6
.
5.
When prompted press
S
to specify the location of
the driver.
6.
Insert the driver diskette, then press
Enter
.
7.
Select
Silicon Image SiI 3x12 SATARaid Controller
for Windows NT 4.0 and 2000
, then press
Enter
.
8.
Press
Enter
to finish driver installation, then follow
the on-screen instructions to complete Windows
2000 installation.
When Windows installation completes, go to
SATARaid
GUI
on page 17 and install the RAID monitoring utility.
For An Existing Installation
1.
Install the board and boot up to Windows.
2.
At the
Found New Hardware Wizard
, click
Next
.
3.
Select
Search for a suitable driver for my device
(recommended),
then click
Next
.
4.
Insert the driver CD, check
CD-ROM drives
, uncheck
the other check boxes, click
Next
, click
Next
again.
5.
Click
Finish
. Remove the driver
CD, shutdown
Windows, and setup your RAID array.
When Windows resumes, go to
SATARaid GUI
on page
17 and install the RAID monitoring utility.
32-bit Windows XP/Server 2003
For A New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the
contents
of the
Floppy
folder, found on the driver CD, onto a blank
floppy disk then follow the directions below.
1.
Setup the RAID array prior to Windows installation.
Summary of Contents for Serial ATA PCI RAID
Page 34: ...34 Blank Page ...
