4
Driver Installation
This section provides information on how to install the
SATA II-150 PCI
drivers for the following operating
systems.
Windows 2000
New Windows 2000 Installation
A new installation of Windows 2000 requires a floppy
disk for the driver installation. To make this floppy disk,
copy the
contents
of the
Floppy
folder, found on the
driver CD, onto a blank floppy disk then follow the
directions below.
1.
Install the board and follow the Microsoft
procedures to install Windows 2000 accordingly.
2.
Restart your system when prompted during
Windows' installation.
3.
At the
Windows 2000 Setup
screen, press
F6
to
install the driver.
4.
Insert the driver
diskette. Press
S
, then press
Enter
.
5.
Select
INITIO INIC1620 S-ATA Adapter For
Windows 2000
and press
Enter
.
6.
Press
Enter
to continue and follow on-screen
instructions to complete the installation.
Existing Windows 2000 Installation
1.
Install the board and boot up Windows 2000.
2.
At the
Found New Hardware Wizard
, click
Next
.
3.
Select
Search for a suitable driver for my device
(recommended)
and click
Next
.
4.
Insert the driver CD, check
CD-ROM drives
, uncheck
the other boxes, and click
Next
. Click
Next
again to
continue.
