4
5.
Set
JP1
-
JP4
jumper settings to the desired voltage
only if your serial device(s) needs additional power
from the serial port. However, most serial devices
do not require additional power. For more
information, see
Figure 1
on page
2
. Skip this step
if power is not required.
6.
To install the card, carefully align the card's bus
connector with the selected PCI slot on the
motherboard. Push the board down firmly, but
gently, until it is well seated.
7.
Replace the slot bracket holding screw to secure the
card.
8.
Replace the computer cover and reconnect the power
cord.
9.
Connect the
4-port fan-out cable
to the board's
44-pin connector
. For more information, see
Figure
2
on page
3
.
Driver Installation
This section provides information on how to install the
CyberPro PCI
4S drivers.
Windows 7 (32-/64-bit)
1.
Install the board and boot up Windows.
2.
At the desktop, right click
Computer
, click
Manage
,
click
Device Manager
.
3.
Insert the driver CD. Right click
PCI Serial Port
,
click
Update Driver Software
.
4.
Click
Browse my computer for driver software
.
5.
Type
D:
, then click
Next
. (Change
D:
to match your
CD/DVD-ROM drive letter)
6.
At Windows has successfully updated your driver
software, click
Close
.
