4
Layout
1. Power LED:
2. Micro-USB:
For technical support only [firmware update]
3. HDMI Signal LED:
Input signal LED indicator (From the left side
to the right is Loopout #1signal LED indicator and Loopout #2
signal LED indicator)
4. Link Receiver LED:
Link LED indicator 1- 4
5. HDMI Signal LED
:
Output signal LED indicator 1- 4
Rear Panel
6. Power jack:
Connect to the DC 12V/7.5A power supply unit
7. EDID Management Rotary control:
8. RS-232(terminal block format):
The order of RS-232 pin are TX,
RX, GND (from the left side to the right)
9. IR Blaster:
Plugging in the extension cable of IR blaster
10. IR Receiver:
Plugging in the extension cable of IR receiver
11. HDMI IN:
Connect to a HDMI input source
12. HDMI LOOPOUT #1:
Connect to a HDMI display
13. HDMI LOOPOUT #2:
Connect to a HDMI display
14. HDMI Signal OUT1-4:
Link to each HDMI display via a Cat-5/5e/6
cable with a HDMI over Cat.X receiver.
15. RJ-45:
Ethernet
TX Front Panel
