Signode AMPT-12, Operation, Parts And Safe

Page: 20 / 36

20
PARTS LISTS & EXPLODED VIEW
GEAR HOUSING
KEY DESCRIPTION QTY. PART NO.
1 SHCS, 1/4-20 x 3/4 3 009041
2 Gear Housing Cover 1 020623
3 O-Ring 1 008546
4 Needle Bearing 1 008549
5 Truarc #5008-75 1 008547
6 Feedwheel Shaft 1 006585
7 Worm Wheel 1 023561
8 Wheel Bearing 2 006563
9 Gear Housing Bushing 1 006581
10 O-Ring 1 006594
11 Gear Housing 1 023564
12 Lock Screw 1 008581
13 Roll Pin 5/64 x 7/16 1 008582
or Cotter pin, 1/16 x 5/8 1 181482
14 Needle Bearing 1 008751
15 Thrust Bearing 1 023754
16 Worm Assembly 1 023563
17 Spacer Ring 1 008534
18 Idler Gear Assembly 3 008815
19 Ring Gear 1 008524
20 Washer 1 008536
!
! !
!
When ordering parts show tool model, part number and name.
!
! !
!
Common hardware parts may be obtained from local hardware suppliers.
! ! ! !
All recommended spare parts are underlined and should be stocked.
GEAR HOUSING DISASSEMBLY & REASSEMBLY
1. Remove the washer (20) the ring gear (19) and the idler gear assembly (18).
2. Remove the roll pin (13) and loosen the lock screw (12) to permit removal of the spacer ring
(17).
3. Remove the worm assembly (16). Note that the thrust bearing (15) must be reinstalled with the
heavy side of the outer race positioned as shown.
4. Remove the three gear housing cover mounting screws (1), then remove the housing cover (2).
Withdraw the feedwheel shaft (6) and the worm wheel (7). Note that the worm wheel (7) must
be reinstalled with the letter "E" positioned as shown.
5. Parts and housing must be free of metallic particles. Clean as required and regrease using
non-fluid oil K-55. Reassembly gear housing by reversing above instructions. Fill gear housing
to approximately 1/2 full.
6. When reassembled, check gearing for freeness by turning worm assembly (16) clockwise
before attaching air motor.