Signode AMPT-12, Operation, Parts And Safe

Page: 17 / 36

17
TOOL HOUSING, DISASSEMBLY & REASSEMBLY
The following instructions cover the removal and replacement of the following tool components:
! ! ! !
Seal Magazine and Sealer Mechanism
!
! !
!
Seal Ejector and Ejector Lever
!
! !
!
Feedwheel
! ! ! !
Gripper Plug
Refer to the exploded views and parts list in this manual for addition information and details.
The following tools are required for perform these operations: 3 Allen wrenches 1/8", 3/16", and
1/4", Truarc pliers, 1/2", 9/16" 3/8" and 1/4" socket wrenches, a rubber mallet, common pliers,
screwdriver and a set of assorted punches.
SEAL MAGAZINE AND SEALER MECHANISM - DISASSEMBLY:
Disconnect the air supply from tool and remove
the seals from the magazine and sealer
mechanism. Release the gripper lever (58) by
pressing the gripper trigger (54). Press motor
latch (41) to drop feedwheel. Loosen cutter
adjustment set screw (44). Remove the two
magazine screws (39 & 42) on the side of the
sealer frame.
Remove the two socket head cap screws (109)
from the bottom of the base. With the tool lying
on its left side, swing the rear of the base down
and away from the sealer frame. Tilt the top of
the magazine away from the sealer mechanism
and lift the magazine assembly out.
The magazine and sealer mechanisms are now
accessible for examination and replacement of
worn or broken parts. The sealer mechanism is
serviced by removing the cutter blade. Clean the
parts. Jaws and crimpers are replaced as
required. After the necessary repairs have been
made grease the parts or apply light machine oil.
The tool is now ready for assembly.
SEAL MAGAZINE AND SEALER MECHANISM - ASSEMBLY:
With the sealer mechanism fully assembled and in place, insert the magazine by placing the lower
portion of the magazine between the sealer mechanism and frame. Tilt the top forward to align
properly with the sealer mechanism.
Swing the base up against the sealer frame. Be sure the strap guide spring (108) is in its proper
position in the base. Insert and tighten the two socket head cap screws (109) through the base.
Insert the top and bottom shoulder screw (39 & 42) through the sealer frame and into the
magazine. Snug - do not tighten.