14
INSTALLATION
LOCATING HEATER
This heater is designed to be mounted on a wall or on a
floor, using the Support Legs included with select models.
For convenience and efficiency, install heater:
Where there is easy access for operation, inspection, and
service.
In the coldest part of room. A minimum of 3’ away from
furniture and draperies.
FLOOR MOUNTING
NOTE: This is an optional accessory and is not
required for operation of the heater.
Cannot be done in bedroom or bathroom
Before installing Support Legs to heater base, please
make sure you have the following items:
(2) Support Legs
(4) Support Leg Screws (ST 3.9×13)
Set down a blanket onto the table where the heater will be
placed for leg installation to prevent scratching of the table
and/or the heater.
Set back of heater on table with the bottom of heater
extending outside the table edge.
Fasten Support Legs to heater using Support Leg Screws
(see Fig. 8).
Note:
If the heater is to be installed directly on carpeting,
tile or other combustible material, other than wood flooring,
the appliance shall be installed on a metal or wood panel
extending the full width and depth of the appliance. Once
positioned, secure heater to the floor using Support Leg
Screws (ST 3. 9×13) and mounting holes found on heater
Support Legs
(see Fig. 8)
.
Fig. 8: Securing Support Leg
Support leg
screw
Support
leg
WARNING:
Failure to position the parts in
accordance with these diagrams or failure to use only
parts specifically approved with this heater may result
in property damage or personal injury.
