Classified
page
7/9/2021
3
ASW25 & ASW75
www.stonco.com
www.keene-lighting.com
5.) According to your embedded
terminal box, punch the corresponding
mounting holes out of the light fixture.
Punch the
mounting holes
6.) Tear off the adhesive paper on the
waterproof pad and stick the waterproof
pad onto the back of the power supply
housing.
7.) Pull the input line wires from the
embedded junction box through the
fixture base and screw the base into the
embedded junction box.
Waterproof pad
Power supply
housing
Screw
9. Screw the case closed with a screwdriver.
10. Install the heatsink assembly and tighten the
screws and fixing knob with a screwdriver to
complete the installation.
8. Install the upper half of the power supply housing
by sliding the hinges together. Then, connect the
incoming Line, Neutral, and Ground wires to the
fixtures outgoing Line, Neutral, and Ground wires. The
purple and gray dimming wires from the driver will be
left disconnected. Adjust the wattage and color
temperature if needed.
Input lines
Red (LED+)
Black (LED
-)
White (LED
-)
Line (Black)
Neutral (White)
Ground (Green)
Gray (DIM
-)
Purple (DIM+)
CCT Selectable
DIP Switch
Wattage Selectable
DIP Switch
Installation Instructions
