6
Signet 8450-1 Pressure Transmitter
Pressure Units:
psi >
Set:
Pressure >
Loop 1 Range: psi
0.0
→
100.0 >
Output1 Mode
Low >
Output1 Setpnt:
10.0
psi >
Output1 Hys:
5 >
Last Cal
06-30-03 >
Select Pressure units for both input channels: psi, bar or kPa.
Provides a maximum 5 psi offset to match 8450 to external reference.
Enter “-999” to restore the original Factory calibration value.
Changes to this setting will become effective when the display exits the Calibrate menu.
Check the 2450 Sensor instructions for the range capability of your sensor.
Be sure to modify this setting if you change the Pressure Units.
Select the mode of operation for the Open Collector output:
OFF, LOW or HIGH.
The Open Collector Output will be activated when the pressure reaches this value. Be
sure to modify this setting if you change the Pressure Units.
The Open Collector Output will be deactivated at setpoint ± Hysteresis (depending on
High or Low selection).
Use this “note pad” to record important dates, such as annual recertifi cation or
scheduled maintenance.
Calibrate Menu
Display
(Factory settings shown)
Description
