6
Stone Trough Console Sink Installation Instructions
Read instructions completely before installing.
Note: Use care when lifting and installing any sink.
Place sink on a level surface with a towel or other
soft cloth beneath to prevent damage.
TOOLS AND MATERIALS:
BEFORE INSTALLING
INSTALLATION
DRAIN INSTALLATION
1. Disassemble the drain by removing the threaded tail piece,
rubber sealing gaskets, friction washer and lock nut from
the drain body.
2. Place thread sealant on the threaded section of the tail piece
and reattach to the drain body.
3. Slide the flat rubber sealing gasket up the tail piece to the top
of the drain body. This gasket will create a water tight seal
between the drain flange and sink.
4. Place the drain in the drain hole in the sink.
5. On the underside of the counter, attach the tapered rubber
gasket. With the flat side facing down, slide the gasket up
the threaded shank until it makes contact with the bottom of
the sink.
6. Slide the friction washer up to meet the rubber gasket.
7. Thread the lock nut onto the threaded shank. Hand-tighten
and make sure that the drain is properly aligned. When ready,
finish tightening with a basin wrench to secure the drain.
Thread Sealant
Basin Wrench
