2
Stone Trough Console Sink Installation Instructions
Read entire Console Sink Installation Instructions.
Observe all local building and safety codes.
TOOLS AND MATERIALS:
Pencil
BEFORE INSTALLING
INSTALLATION
CONSOLE SINK
1. Position the console legs on the floor to prepare for assembly.
Each leg has a 4-way ball joint with included set screws.
2. Attach the horizontal supports to the ball joints and tighten
the set screws.
3. Once assembled, place the sink stand against the wall and in
line with wall studs or wood blocking. Make sure the stand is
level. If needed, adjust the small screws under each leg.
4. Mount the flanges to the wall with the included screws. Each
flange has three screws.
Note: Undermount sinks should be installed at this point. See the “Sink
Installation Instructions” below before continuing to Step 5. For semi-re-
cessed and vessel sinks, continue through the following steps, then install
sinks using the “Sink Installation Instructions.”
5. Apply a thin coat of silicone to the tops of the sink stand
where the vanity top will rest.
6. Carefully place the vanity top on the sink stand, center it and
allow silicone to dry for 24 hours..
SINK SUPPORT
T-shaped brackets hold the underside of the counter top to the
wall and can be used with either side supporting the counter.
We recommend installing the brackets using drywall screws and
attaching to wall studs or to a wood-blocked area.
1. Using a pencil, mark the position for the support bracket by
centering it under the vanity top and against the wall.
(For double sinks, center a bracket behind each drain cutout.)
2. Place the bracket back under the vanity top, securing the side
with silicone to the underside of the top and the other
side against the wall with drywall screws.
3. Allow silicone to dry for 24 hours.
Level
Screwdriver
Drill
Silicone Sealant
INSTRUCTIONS
Unpack and inspect the product for any shipping
damages. If you find damages, do not install.
Contact Customer Service at 1.866.855.2284. If you
need assistance or have questions while installing
your sink, contact Customer Service.
For adequate wall support, we recommend using
heavy-duty steel wall anchors and placing wood
blocking inside the wall. We recommend consulting
a professional if you are unfamiliar with installing
bathroom fixtures. Signature Hardware accepts no
liability for any damage to the sink or wall, or for
personal injury during installation.
BACKSPLASH
For counters with a backsplash, apply silicone to
the backsplash's edge and wall-facing side.
Position the backsplash to the rear of the counter
and against the wall. Allow silicone to dry.
