Chapter 8
| Authentication Commands
802.1X Port Authentication
– 241 –
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x re-authentication
Console(config-if)#
Related Commands
dot1x timeout re-authperiod (241)
dot1x timeout
quiet-period
This command sets the time that a switch port waits after the maximum
request count (see
) has been exceeded before attempting to
acquire a new client. Use the
no
form to reset the default.
Syntax
dot1x timeout quiet-period
seconds
no dot1x timeout quiet-period
seconds -
The number of seconds. (Range: 1-65535)
Default
60 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#
dot1x timeout
re-authperiod
This command sets the time period after which a connected client must be re-
authenticated. Use the
no
form of this command to reset the default.
Syntax
dot1x timeout re-authperiod
seconds
no dot1x timeout re-authperiod
seconds -
The number of seconds. (Range: 1-65535)
Default
3600 seconds
Command Mode
Interface Configuration
