Signamax
065-1163T RS-232/422/485 to 10/100BaseT/TX Media Converter
Configuration
23
Command Line Interface (Telnet)
The media converter is accessible via a remote computer
using Telnet. After completing the steps outlined to connect
the devices (see Connection to Data Terminal Equipment in
previous chapter), proceed with the directions below to
login to the management facility using a remote computer.)
The converter is preset with a factory IP address that must
be configured to the user’s individual IP address. It is
important to do this so that the converter doesn’t conflict
with other devices with the same defaults.
NOTE: Prior to following the instructions listed below for
Remote Computer Login, ensure that a serial cable
connection between the media converter and remote
workstation exists.
Remote Computer Login
1. The default Login name is
“admin
” with no preset
password. After successful login, type the following
command line to change the device IP address in CLI mode
where
xxx
’s represent values between
0
and
254
and the
user should enter their own IP address in this form.
• telnet
xxx.xxx.xxx.xxx.
2. After entering the new IP address, the system will confirm
that the operation is successful.
