46
5.2 Ink refill
When the hearing six-‐consecutive buzz, check and see if the ink is running out from the main inks
tanks
Filling instructions
Step one. Get a new bottle of ink and uncap it, put it nearby.
Step two. Uncap the main ink tank which needs to be refilled. Carefully shake the ink of the new
bottle prior refilling it into the main tank.
5.3 Replacement of ink filter
The ink filter requires seasonal replacement.
Replacement instructions
Step one. Disconnect the power cable connection of the ink pump.
Step two. Clamp the outlet tube so as to avoid ink leaking or withdrawal.
Step three. Disconnect the joints of the tube and the filter. Remove the filter.
Step four. Replace with a new one and pay attention to the flow direction indicated by the arrow
mark on the filter.
Step five. Remove the clamp and reconnect the power cable connection of the ink pump.
Note. The buzzer might probably generate three-‐consecutive buzz in the process of replacing. You will
need to reset the alarm in the Topjet software after the replacement. With a new filter it could be
possible that the pump cannot push the air out of the main ink filter. Take a syringe to extract the air
from the outlet of the main ink filter. To do this procedure, clamp the outlet tube and disconnect it
from the main ink filter. Add a syringe to the outlet of the filter and make a reset in the Topjet
software. The pumps will be activated again, and gently suck the ink inside the syringe. When the
syringe is filled, reconnect the main ink filter with the ink tube. Reset the Topjet software to fill the
subtanks.
Summary of Contents for 1600 LED
