![background image](http://html.mh-extra.com/html/sigma/18-30-171/18-30-171_installation-instructions-manual_1267781002.webp)
AMERICAN
American Faucet & Coatings Corporation
Installation Instructions
Connections
-Important-
Connect the hot water to the side with the
red mark and the cold water to the side
with the blue mark.
The black housing should act as a
depth guide for the plumber. Install
the valve so the housing extends
FINISH wall. The black housing is to
remain with the valve body always for
maintenance reasons.
Valve is shipped with standard
extensions.
Assembly
and discard temporary construction cover
(14). Retain 2 screw(s) (8). Install combi-
nation cover cartridge (3) and secure in
place using 2 screws (8).
Fit the threaded tube (9), and tighten
onto cover. Place the cover plate (7) and
the dial (11) onto the assembly. Make a
cutting mark 3/16" from the dial face.
Remove the tube, cut it, and debur the
cut carefully. Tighten the tube onto cover
again.
- Screw the bushing
(12)
onto the threaded
tube. Slide the square tube (10) into the
bushing and drive it completely into the
control spindle.
- Make a cutting mark on the square
square tube, cut it, and debur carefully.
Replace the tube into the bushing and
push it all the way into its recess.
Flushing Lines
Flush the supply pipes completely and carefully
by closing the body with the temporary construc-
tion cover (14). Keep foreign matter OUT of the
cartridge. Install only after hot water heater is
working.
Page 2
AMERICAN
Revised 7-12-19
FORM SIG 063