Version 04/2008, Rev. 1.18 of 07/06/2012
page 36 of 65
Translation of the original operating manual
5.3.5
Program
The program is used to save or load certain recurrent settings of the centrifuge.
This saves time and prevents typing errors. Ten different programs (0-9) can be
saved and called up. This is only possible at a standstill.
5.3.5.1 Saving the Current Settings
To save the current settings:
•
Turn the left rotary knob until “save” appears on the display (Fig. 5.16).
•
Select the option by pressing the right rotary knob. “Save” will now flash.
•
Turn the right rotary knob until the desired program number is displayed.
Empty storage location numbers flash.
•
Press the right rotary knob to confirm the input.
The settings are now saved under this program number (program number 8 in
the example).
5.3.5.2 Calling Up Stored Programs
If necessary, the saved programs can be called up:
•
Turn the left rotary knob until “run” appears on the display (Fig 5.17).
•
Select the option by pressing the right rotary cursor. “Run” will now flash.
•
Turn the right rotary knob until the desired program number is displayed.
•
Press the right rotary knob to confirm the input.
The saved program settings will be adopted.
Fig. 5.16: Saving the programs;
here program number 8
Fig. 5.17: Calling up stored programs;
here program number 8
