Sigma V KT848, Installation Manual

Page: 35 / 48

Page 31
Program 27: Special port setting
The upper row display: Special port
The lower row display: XXX (Extension port number)
DID : XXX (Default: NIL)
Console 1 : XXX (Default: 001)
Console 2 : XXX (Default: NIL)
Console 3 : XXX (Default: NIL)
If system uses the function of Trunk-to-Trunk or non-supervise meeting of two COs,
then an extension port should be set as the connect-bridge for phoning between two
lines. The present extension must select between extension ports 001 - 008, and the
selected should be leisure port.
Programming for single line phone:
Enter DISA port number and then press the # key
Note: Single line phone is not allow to set operator in this program
Program 28: Initialize the system
The upper row display: SYSTEM RESET
The lower row display: X
X: 1 for initialize (warning: all data will be lost)
This item of setting can restore the system setting to default, including system
password.
Programming for single line phone:
Press 1 for reset and restore to default setting