CP6000/CP4000
28 Current Probe Instructions
Certifications and compliances
EC
Declaration
of Conformity
Low Voltage
Compliance was demonstrated to the following specification as listed in the
Official Journal of the European Union:
Low Voltage Directive 73 / 23 / EEC,as amended by 93 / 68 / EEC
EN 61010-1/A2:1995
Safety requirements for electrical equipment for measurement, control, and
laboratory use.
EN 61010-2-032:1995
Particular requirements for hand-held current clamps foe electrical
measurement and test equipment.
Additional
Compliance
IEC61010-1/A2:1995
Safety requirements for electrical equipment for measurement, control, and
laboratory use.
IEC61010-2-032:1994
Particular requirements for hand-held current clamps foe electrical
measurement and test equipment.
Installation
(Over
voltage)
Category
Terminals on this product may have different installation (over voltage)
category designations.
The installation categories are:
CAT III
Distribution-level mains (usually permanently connected). Equipment at this
level is typically in a fixed industrial location
CAT II
Local-level mains (wall sockets). Equipment at this level includes appliances,
portable tools, and similar products. Equipment is usually cord-connected.
CAT I
Secondary (Signal level) or battery operated circuits of electronic equipment.
Pollution
Degree
A measure of the contaminates that could occur in the
environment around and within a product.
Typically the internal environment inside a product is considered to ne the
same as the external.
Products should be uses only in the environment for which they are rated.
Pollution 1
No pollution or only dry, nonconductive pollution occurs. Product in this
category are generally encapsulated, Hermetically sealed, or located in clean
rooms.
Pollution 2
Normally only dry, nonconductive pollution occurs. Occasionally a temporary
conductivity that is caused by condensation must be expected. This location
is a typical office/home environment. Temporary condensation occurs only
when the product is out of service.
Summary of Contents for CP4000 Series
Page 1: ...Current Probe Instructions ...
Page 2: ......
