background image

10 

 

IV.

 

WARNING STATEMENTS 

 

1.

 

FCC: 

 

This device complies with Part 15 of the FCC Rules. 

 

Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference, and 
(2) This device must accept any interference received, including interference that 
may cause undesired operation. 

 

The radiated output power of the device is far below the FCC radio frequency 
exposure limits. Nevertheless, the device shall be used in such a manner that 
the potential for human contact during normal operation is minimized. 

 

Changes or modifications not expressly approved by the party responsible for 
compliance could void the user's authority to operate the equipment 
 

 

NOTE: This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed 
to provide reasonable protection against harmful interference in a residential 
installation.  This equipment generates, uses and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications.  However, there is no guarantee that 
interference will not occur in a particular installation.  If this equipment does cause 
harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures: 

 

Reorient or relocate the receiving antenna. 

 

Increase the separation between the equipment and receiver. 

 

Connect the equipment into an outlet on a circuit different from that to which 
the receiver is connected. 

 

Consult the dealer or an experienced radio/TV technician for help. 

 

2.

 

 IC 

 

English 
This device complies with Part 15 of the FCC Rules and with Industry Canada license-
exempt RSS standard(s). 
Operation is subject to the following two conditions: 
this device may not cause harmful interference, and 
this device must accept any interference received, including interference that may 
cause undesired operation. 
 
Français 
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux 

Summary of Contents for SNT1.1-1












Reviews: