.
4.
Cut a piece of 1/16" x 1/2" balsa sheeting and glue in place on top of the 1/8" sq. balsa and flush with the top of the wing.
5.
Cut a piece of 3/16" x 1/4" balsa to fit in between the ribs as shown on the plans. Drill a 1/8" hole through the center of it to
allow the plastic tubing to fit through. Glue the balsa piece in place.
6.
Using heat, pre-bend the plastic tubing to the shape shown on the plans. Drill 1/8" holes through the ribs at the locations
shown on the plans to allow the tubing to pass through. Slip the tubing in and glue in place.
7.
Cut and bend a piece of 1/32" music wire per pattern and epoxy glue in place as
shown on the plans. Also epoxy glue a small piece of glass cloth over the wire.
8.
Repeat this process for the other wing and then continue with the wing
construction.
After covering the wing and the spoilers make hinges for the spoilers out of pieces
of plastic film covering or trim tape and install the spoilers. Feed the cord through
the plastic tubing from the servo hook-up side of the tubing. Connect the cord to
the wire on the spoilers. Make the servo hook-up wire per pattern. Both pieces of
cord from the spoilers are connected to this. The exact placement of the hook
depends on where your servo is installed. Connect the hook to the servo. Both
spoilers should come up at the same time andboth should open the same amount.