.
80.
Sand the wing tip flush with the end rib.
81.
Cut the ailerons and center section trailing edge out of the shaped 1/4"x3/4"
aileron stock.
NOTE: The aileron horns are offset from the wing center line to allow extra radio
room in the fuselage.
82.
Mark the location of the aileron horns on the trailing edge as indicated on the
plans.
83.
Hollow out the trailing edge piece where the aileron horns will fit. Note that one of the aileron horn bearings must be
shortened. Cut through the plastic tube with a modeling knife.
84.
Roughen the plastic tube of the aileron
horns with a piece of sandpaper. Epoxy
glue the aileron horns into place. Be
sure that they are flush with the front of
the piece and that there is no binding or
friction caused by glue leakage into the
bearing.
85.
Epoxy the assembly into place on the
wing.
86.
Drill a hole into the aileron to accept the
aileron horn.
87.
Groove the aileron to take the aileron
horn wire, then check the fit. Use the
instructions at right to hinge both the
ailerons and the elevator with Easy
Hinges. For best results, cover the
model before hinging. Be sure to epoxy
the aileron torque rods in the ailerons as
you are performing the second step in
the hinging instructions.
Page 11 of 14
Sig Hummer SIGRC50 Instruction Manual