.
20. Remove the 1/8" Lite-Ply landing gear
plate from the die-cut sheet and epoxy
glue in place on the bottom of the
fuselage and F-2.
21.
Glue and pin the forward fuselage
bottom. This is cut, as indicated, from
the 1/8" balsa printed sheet.
22.
Cut cross-grain pieces of 1/16" balsa
sheeting for the fuselage bottom.
23.
Bottom sheeting completed.
24.
Sand the rough edges.
25.
Cut an exit hole for the nylon tubing
push rod as indicated on the plans.
Insert the tubing but do not glue in
place.
26.
a. Place the elevator servo to be used in position.
b. Insert the inner tubing into outer tubing and use this to align the outer tubing with the servo. Glue the outer tubing in
place with epoxy.
27.
Use a razor blade to cut the outer tubing off flush with the fuselage side.
28.
Use scrap 1/16" balsa for the fill-in piece. The fill-in piece is glued in between the two fuselage sides and is flush with the
top.
Page 5 of 14
Sig Hummer SIGRC50 Instruction Manual