Sierra INNOVA-MASS 240-VT, Instruction Manual

Page: 9 / 146

Chapter 1 Introduction Sierra 240/241 Series Instruction Manual
1-2 IM-240
Note and Safety Information
We use note, caution and warning statements throughout this book to
draw your attention to important information.
Warning!
Caution! Note
This statement appears with
information that is important to
protect people and equipment
from damage. Pay very close
attention to all warnings that
apply to your application. This statement appears with
information that is important
for protecting your equipment
and performance. Read and
follow all cautions that apply
to your application. This statement appears with
a short message to alert you
to an important detail.
Receipt of System Components
When receiving a Sierra Instruments mass flow meter, carefully check
the outside packing carton for damage incurred in shipment. If the carton
is damaged, notify the local carrier and submit a report to the factory or
distributor. Remove the packing slip and check that all ordered compo-
nents are present. Make sure any spare parts or accessories are not dis-
carded with the packing material. Do not return any equipment to the
factory without first contacting Sierra Instruments’ Customer Service.
Technical Assistance
If you encounter a problem with your flow meter, review the configura-
tion information for each step of the installation, operation and set up pro-
cedures. Verify that your settings and adjustments are consistent with fac-
tory recommendations. Refer to Chapter 5, Troubleshooting, for specific
information and recommendations.
If the problem persists after following the troubleshooting procedures
outlined in Chapter 5, contact Sierra Instruments, Technical Support at
(800)-866-0200 or (831) 373-0200 between 7:30 a.m. and 5:00 p.m.
MST. When calling Technical Support, have the following information
on hand:

the serial number and Sierra order number (all marked on the
meter nameplate)

the problem you are encountering and any corrective action
taken

application information (fluid, pressure, temperature and
piping configuration)