Rev 1.0 Mar.10
37
•
Power
- Indicates the power adapter is connected and there is power getting
to the Raven X.
•
The
Reset button
(on the left side of the Raven X) has two functions. If it is
quickly depressed and released, the modem will simply power cycle the
internal hardware. If, however, the reset is depressed and held for several
seconds (count 10 slowly, and wait for the power light to go off after the light
pattern stops), the ALEOS configuration settings will return to the factory
defaults.
Light Patterns
The LEDs on the front of the modem will respond in different patterns to indicate
modem states.
•
Normal
- Each LED, mentioned above, is lit as applicable.
•
Start up
- The LEDs will cycle from left to right.
•
PassThru mode
- Network and Signal LEDs will blink in tandem. The
Activity LED will blink when transmitting or receiving data.
•
SOS
- The Network and Service Err or Service LEDs will blink alternate to
each other.
•
Configuration Reset
- The LEDs will cycle left to right and then right to left 4
times.
•
Authentication Failure
- The Network, Signal, and Activity LEDs blink every
2 seconds.
•
Data Retry
- The Network, Signal, and Activity LEDs blink every 3 seconds.
•
Invalid MAC Address or Ethernet Initiation Fail
- The Service LED will
blink.
Mounting
The integrated mounting with keyhole screw mounts on the Raven X will allow you
to secure your modem nearly anywhere, quickly and easily, without the need for a
separate bracket.
Caution:
If you reset the modem configuration using the reset button,
you may need to reactivate your Raven X with Alltel.
