LASSEN SERIES 16 & 32 HD/SDI
37
“X”: Connect Crosspoint
Use command X to request that a connection be made. It must be followed by an output number,
a comma, an input number, a comma, and a level number. For example:
**X8, 3, 2!!
This string says that a connection is to be made between output 8 and input 3 on level 2. If the
level number is specified as “0”, this means that the connection is to be made on all levels (AFV).
For example, the command:
**X8, 3, 0!!
This string says that a connection is to be made between output 8 and input 3 on all levels.
“Y”: Connect AFV
Use command Y to request that a connection be made. It must be followed by an output number,
a comma, and an input number. The connection is made on all levels (AFV). For example, the
command:
**Y2, 8!!
This string says that input 8 is to be connected to output 2 on all levels.
“Z”: Connect AFV
The command "
Z
" is used to request that a connection be made. It must be followed by a comma-
separated list of input numbers, one for each output, up to the number of outputs in the router.
Fewer than the number of outputs may be specified if desired, and the remaining outputs will be
left unchanged. The connection is made on all levels (AFV).
For example, the command:
**Z4,18,7!!
says that input 4 is to be connected to output 1 on all levels, input 18 to output 2 on all levels, and
input 7 to output 3 on all levels.
An input number of 0 means the output connection is to be left
unchanged
.
An input number of ë-ë (dash) means the output is to be
disconnected
. If the router does not
support disconnected outputs, the output connection will be left unchanged.
Any input or (implied) output number may be specified as long as it exists on at least one level.
No connection will be made on any level on which an input or (implied) output number does not
exist. If the requested connection has an output or input number that isn’t mapped to a physical
connector (on virtual-mapped routers) on one or more levels, those levels are simply not
changed.
If “U2” is in effect (see “U” command), the response will include one or more V, Y, or X
commands to report the new status of the outputs. The response will be the same as if “O”
commands were issued for the outputs immediately following the “Z” command. No response is
generated if this command is being used to define a salvo.
