MODEL 90154720T
Crescent 2 Person Dome
7’ x 4’6”
IMPORTANT:
WE ADVISE YOU TO ASSEMBLE THE TENT ONCE BEFORE
GOING CAMPING TO BECOME FAMILIAR WITH THE ASSEMBLY OF THE TENT.
NOTE:
PLEASE LOOK AT THE REPLACEMENT PARTS DIAGRAM TO SEE HOW
YOUR FRAME IS ASSEMBLED. TO PROLONG THE LIFE OF THE TENT FLOOR,
SELECT A LEVEL, CLEAN AREA FOR THE CAMPSITE. TO PREVENT DAMAGE
TO THE ZIPPER, UNZIP THE DOOR TO ALLOW AIR TO ENTER THE TENT.
TO IMPROVE THE WEATHER RESISTANCE OF YOUR TENT, IT IS ADVISABLE
TO USE SEAM SEALER TO COAT ALL EXPOSED SEAMS. YOU SHOULD APPLY
ONLY TO THE UNDERSIDE OF THE FLY AND INSIDE SEAMS OF THE TENT.
IF APPLIED TO THE OUTSIDE OF SEAMS, DISCOLORATION OF YOUR TENT
MAY OCCUR.
ASSEMBLY INSTRUCTIONS
STEP 1:
Spread tent out flat, floor side down.
STEP 2:
Stake the tent to the ground by inserting stakes
though the webbing loops at the side corners of the tent.
Hammer the stakes into the ground at a 45° angle, making
sure the tent floor is pulled out even and tight.
STEP 3:
Extend fiberglass tent poles by pulling out each section and placing it
into the metal ferrule connectors. You will have 2 large diameter (light grey)
and 1 small (black) awning poles. The two longest poles (A) are the main tent
poles. The other smaller pole (B) will be used with the tent fly.
STEP 4:
Position poles so that
they form an “X” across the tent.
STEP 5:
Starting at the back of the tent, Insert the ends of each
pole (A) into the grommet holes in the corner webbing tabs at
base of tent.
STEP 6:
Go to the front of the tent and flex the main pole creating
an arch and place the metal end of the pole into the hole at the
base of the tent. Clip plastic hooks to the frame. Repeat for the
second main tent pole.
STEP 10:
Guy lines are attached to the tent for
additional stability. Extend the guy lines and make
a loop at opposite end by using the slider (as shown).
Place the loop over a stake and stake to the ground
at 45° angle. Adjust slider to make guy rope tight.
Tent should appear
as shown.
NOTE:
To take down tent, follow steps above in the reverse order. Be sure to
leave door unzipped. Place stakes into stake bag and poles into pole bag, which
are provided. The tent should be folded into equal parts toward the center to
distribute the bulk. Fold fly and lay on top. Start a small tight roll, the width of
your carry bag, with the pole bag placed at the end opposite the doors. Roll
tent toward doors to allow air to escape. Once rolled, secure with strings or rope
and place into carry bag.
MAKE SURE TENT IS CLEAN AND DRY BEFORE STORING.
Tent should appear
as shown.
A
A
B
STEP 7:
Unfold fly and place over tent so the zippered opening is
located over the door.
STEP 8:
Locate the fly pole sleeve on the inside of the tent fly
above the door. It is marked with colored binding. Insert fly pole
into sleeve. Attach the fly pole to the tent by flexing the fiberglass
pole and inserting each end into the metal grommets above the
door. Grommets are located on either side of the front door.
STEP 9:
Attach the fly to the tent by fastening the
hook and loop fasteners on the underside of the fly
to the main fiberglass poles at all locations. Attach
buckle on the fly to the base of tent. Tighten as needed.
NOTE:
A mesh gear loft is also included with your tent.
Attach to the tent ceiling to hold small camping items
within easy reach.
