Siemens WT45HVE6DN, User Manual And Installation Instructions

Page: 40 / 48

en
Troubleshooting
40
Fault Cause and troubleshooting
Water is leaking from
the appliance.
▶
Clean the seal for the heat exchanger cover.
→
"Cleaning the filter system on the base unit",
Page 28
Water drain hose is not connected correctly.
▶
Ensure that the water drain hose is connected cor-
rectly.
The lever for the heat exchanger cover is not closed
correctly.
▶
Ensure that the lever for the heat exchanger cover
is closed correctly.
→
"Closing the base unit", Page 35
The laundry is too
damp. Unsuitable programme for the type of fabric.
▶
Set a timed programme for the subsequent drying.
→
"Programmes", Page 22
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The load is too large.
▶
Observe the maximum load capacity of the
→
"Programmes", Page 22 .
After the end of the programme, warm laundry feels
damper than it actually is.
1.
Remove the laundry from the drum as soon as the
drying programme has finished.
2.
Spread the items of laundry for cooling.
Unsuitable dryness level set.
▶
→ "Changing the dryness level", Page 21 .
Drying target not adjusted.
▶
→ "Adjusting the dryness level", Page 21 .
Load too small.
▶
Set a timed programme for the subsequent drying.
→
"Programmes", Page 22
Moisture sensor dirty.
▶
→ "Cleaning the moisture sensor", Page 35 .
The drying process is interrupted and the condensa-
tion tank has been filled.
1.
→ "Emptying the condensation container", Page 30 .
2.
→ "Inserting the condensation container", Page 30 .
3.
→ "Starting the programme", Page 26 .