Signal setting
en
29
M
Signal setting
Signal setting
You can change the following settings:
■
The spin speed that is used for
spinning your laundry before it is
dried,
■
The volume of the audible signal at
the end of the programme,
■
The volume of the audible button
signals.
You will need to activate the setting
mode in order to change these settings.
Activating the setting mode
1.
Switch the dryer on.
2.
Select the "Cottons" programme in
position 1 and wait for five seconds.
Setting mode is now activated. The
symbols go out on the display panel
and the programme duration is
displayed.
1.
Press and hold the Start button and,
at the same time, turn the
programme selector clockwise to
position 2.
2.
The
spin speed
is shown on the
display.
3.
Press the "Ready in" time button or
the drying time button to change the
spin speed.
4.
Turn the programme selector
clockwise to position 3.
5.
The volume for the
audible signal at
the end of the programme
is shown
on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
6.
Press the "Ready in" time button or
the drying time button to change the
volume.
7.
Turn the programme selector
clockwise to position 4.
8.
The volume for the
audible button
signal
is shown on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
9.
Press the "Ready in" time button or
the drying time button to change the
volume.
Note:
You can select other positions
with the programme selector; however,
you will be unable to change these
settings.
Finishing setting mode
Turn the programme selector to the
"Off" position once you have set the
required spin speed and the volume.
The settings have now been saved.
