Programme default settings
en
15
0
Programme default
settings
Programme default settings
The temperature, spin speed and
programme duration (Ready in time) for
all programmes are preset at the
factory.
These are displayed in the display panel
after selecting the programme.
You can change the default settings as
follows.
Temperature
Depending on the programme
progress, you can change the preset
washing temperature (in °C) before and
during the programme.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
The maximum temperature that can be
set depends on the programme which
has been selected.
Overview of programmes
Spin speed
Depending on the programme
progress, you can change the spin
speed (in rpm; revolutions per minute)
before and during the programme.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
Setting – – – : Rinse hold = without final
spin, the laundry remains in the water
after the final rinse.
You can select "Rinse hold" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
Maximum spin speed depends on the
programme and model.
Overview of programmes
Ready in
The respective programme duration is
displayed by selecting the programme.
The programme duration is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings also change the
programme duration.
Before starting the programme, the
programme end
0
(Ready in) can be
pre-selected in increments of one hour
(h = hours) up to a maximum of 24
hours.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
Note:
The programme duration is
included in the selected Ready in time.
After the start, the preselected time e.g.
8h
is displayed and the time counts
down to the start of the wash
programme. The programme duration is
then displayed, e.g.
2:30
(hours:minutes).
Changing the preselected time:
You can change the preselected time
before the start of the programme as
follows:
1.
Select
!
Start/
Reload
.
2.
Press the
0
(Ready in) button
repeatedly until the required number
of hours is displayed.
3.
Press the
!
Start
/Reload button.
Adding laundry while the pre-selected
time continues running:
1.
Select
!
Start/
Reload
.
2.
The symbols
YES
and
v
light up in
the display panel. The washing
machine door can be opened and
laundry can be added.
3.
Close the washing machine door.
4.
Press the
!
Start
/Reload button.
The preselected time continues to
run.
