Cleaning and maintenance
en
23
6.
Reinsert and screw on the pump
cover. Handle should be vertical.
7.
Close the service flap.
Note:
To prevent unused detergent
from flowing into the outlet during the
next wash: Pour 1 litre of water into
dispenser
II
and start the
0
Spin/
Drain
p
programme: (if only a drain
cycle is required: set rpm (spin speed)
to - - -).
The drain hose at the siphon
is blocked
1.
Set the programme selector to the
“Off” position. Pull out the mains
plug.
2.
Loosen hose clip and carefully
remove drainage hose.
Residual water may run out.
3.
Clean the drainage hose and siphon
connecting piece.
4.
Re-attach the drainage hose and
secure the connection point using
the hose clip.
Filter in the water supply
blocked
First, reduce the water pressure in the
inlet hose:
1.
Turn off the tap.
2.
Select any programme (except
0
Spin/Drain
p
).
3.
Select the Start button. Allow the
programme to run for approx. 40 s.
4.
Set the programme selector to the
"Off" position. Pull out the mains
plug.
5.
Clean the filter on the tap:
Disconnect the hose from the tap.
Clean the filter with a small brush.
6.
Clean the filter on the back of the
appliance:
Remove the hose from the back of
the appliance.
Use pliers to remove the filter and
then clean it.
7.
Connect the hose and check for
leaks.