en
Operating the appliance
18
Child lock
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the child lock when the
programme has started.
To activate/deactivate the child lock,
press and hold the Start button for
approx. 5 seconds. The
w
symbol
appears in the display panel.
■
w
lights up: The child lock is active.
■
w
flashes: The child lock is active,
and the programme selector has
been adjusted. To prevent the
programme from stopping, turn the
programme selector back to the
original programme. The symbol
lights up again.
Note:
The child lock may remain
activated until the next programme
starts, even after the washing machine
has been switched off. You must then
deactivate the child lock before starting
the programme and activate it again as
necessary once the programme has
started.
Adding laundry
After starting the programme, you can
add or remove laundry if necessary.
To do this, select the Start button. The
washing machine checks whether
adding laundry is possible.
If the following appears in the display
panel:
■
Both
the
YES
and
v
symbols light
up, it is possible to add laundry.
■
NO
and
v
flash, wait until
YES
and
v
light up. Do not open the door
until
both
the
YES
and
v
symbols
light up.
■
NO
lights up, it is not possible to add
laundry.
Notes
■
For safety reasons, the door remains
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Select the Start button to continue
the programme.
■
Do not leave the door open for a
prolonged period - water could run
out of the laundry.
Changing the programme
If you have started a wrong programme
by mistake, you can change the
programme as follows:
1.
Select the Start button to pause the
programme.
2.
Select another programme.
3.
Select Start button for starting the
programme. The new programme
starts from the beginning.
Cancel the programme
For programmes at high temperatures:
1.
Select the Start button to pause the
programme.
2.
To cool down washing: Select
q
Rinse programme.
3.
Select the Start button.
For programmes at low temperatures:
1.
Select the Start button to pause the
programme.
2.
Select
0
Spin
/Drain
p
(if only a
drain cycle is required: set rpm (spin
speed) to - - -).
3.
Press the Start button again.