en
Troubleshooting
60
Errors
Cause
Troubleshooting
The water is not draining.
Rinse Hold
is activated.
▶
Continue the programme by select-
ing
Spin
or
Drain
and pressing
.
the programme status is Rinse Hold",
Page 42
The water outlet hose is con-
nected too high.
▶
Install the water outlet hose at a max-
imum height of 1 metre.
Water is not flowing in. Deter-
gent is not being dispensed.
You have not pressed
.
▶
Press
.
The filter in the water inflow is
blocked.
▶
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked
or jammed.
▶
Ensure that the water inlet hose is not
kinked or jammed.
The spin cycle runs several
times.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
▶
Not a fault – no action required.
Note:
When loading, where possible,
place large and small items of laundry to-
gether in the drum. Different sized items
of laundry distribute themselves better
during the spin cycle.
The programme duration
changes during the wash
cycle.
The programme operation is
optimised electronically. This
may change the programme
duration.
▶
Not a fault – no action required.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
▶
Not a fault – no action required.
Note:
When loading, where possible,
place large and small items of laundry to-
gether in the drum. Different sized items
of laundry distribute themselves better
during the spin cycle.
Foam detection system
switches on a rinse cycle if
foam build-up is too high.
▶
Not a fault – no action required.
No water is visible in the
drum.
Water is below the visible
area.
▶
Not a fault – no action required.
Drum jerks after the pro-
gramme starts.
This is caused by an internal
motor test.
▶
Not a fault – no action required.
Vibrations and movement of
the appliance whilst spinning.
Appliance is not correctly
aligned.
▶
Summary of Contents for WM6HXEL0DN
Page 71: ......
