Siemens WM6HXE0LDN, User Manual And Assembly Instructions

Page: 67 / 76

Troubleshooting
en
67
Problem with results
Fault Cause troubleshooting
Creasing. The spin speed is too high.
▶
The next time you run a wash cycle,
set a lower spin speed.
The load is too large.
▶
The next time you run a wash cycle,
reduce the amount of laundry being
loaded.
The wrong programme is se-
lected for the type of fabric.
▶
Select the programmes that are
suitable for the type of fabric.
→ "Programmes", Page 29
The spin result is not satis-
factory. The laundry is too
wet/too damp. A low spin speed is selected.
▶
The next time you run a wash cycle,
set a higher spin speed.
▶
Start the
Spin
programme.
Less Ironing is activated.
▶
Select the programmes that are
suitable for the type of fabric.
→
"Programmes", Page 29
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
▶
Redistribute the laundry in the
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
▶
Start the Spin programme.
Detergent residue on the
damp washing. Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
▶
Start the
Rinse
programme.
Unsuitable detergent added
to the dispenser of the intelli-
gent dosing system.
1.
Check whether the detergent used
is suitable.
→ "Detergents and care products",
Page 41
2.
Drain the dispenser.
→
"Cleaning the detergent drawer",
Page 54
3.
Clean the dispenser.
4.
Refill the dispenser.
→
"Filling the dispenser", Page 46
Basic dosage is not correctly
adjusted.
▶
If intelligent dosing is activated, re-
duce the "basic dosage"
→ Page 47 .