NLTroubleshooting
Malfunction
"E:30 / -80"
Cause and Troubleshooting
▶
Remove any unauthorized extensions from the
water drain hose.
"Connecting the device", page 16
Pump cover is not fully screwed in.
▶
Make sure that the pump cover is screwed into the
device as far as it will go. The pump cover handle
must be vertical.
"E:36 / -25 / -26"
"E:38 / -25 / -26"
Drain pump is clogged.
▶
"Cleaning the drain pump", page 37
Drain pump is clogged.
▶
if the error is displayed again,
▶
"Cleaning the drain pump", page 37
Inlet opening of the rubber sleeve is clogged.
▶
"Clean the inlet opening in the rubber sleeve",
"E:60 / -2B"
The unbalance detection system has interrupted the
spin cycle due to uneven distribution of the laundry.
▶
Redistribute the laundry in the drum.
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
"E:30 / -10" and/or
Water pressure is low.
No solution possible.
Strainer in the water supply is clogged.
▶
Clean the strainer in the water supply.
Water tap is closed.
▶
Open the water tap.
Water supply hose is kinked or pinched.
▶
Make sure that the water supply hose is not
kinked or pinched.
Water level measuring system defective.
Remark:With the error message, the device starts a
pump-down procedure.
1.
First, wait for approx. 5 minutes until the pump-down procedure
has ended.
2.
To reset the error message, turn off the device.
42
