Siemens WM16XK75NL, User Manual

Page: 52 / 64

NLTroubleshooting
Malfunction
Cause and Troubleshooting
▶
No error - no action required.
The program duration
changes during the wash
cycle.
Remark:When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Foam control system provides an extra rinse when
foaming is too high.
▶
No error - no action required.
The water is not
visible in the drum
bar.
The water is below visible range.
▶
No error - no action required.
▶ Do not fill the device with additional water during
operation.
Drum jerks after
program start.
The cause is an internal motor test.
▶
No error - no action required.
Vibration and movement
of the appliance
during the spin
run.
The appliance is not leveled properly.
▶
→ "Adjusting the device", Page 17
Device feet are not fixed.
▶
Secure the device feet.
→ "Adjusting the device", Page 17
Transport protections have not been removed.
▶
→ "Remove transport locks", page 14.
Drum is spinning, er
no water flows into
the appliance.
Load recognition is active.
▶
No error, no action necessary.
Remark:The load detection can take up to 2 minutes.
strong foam
ming.
Detergent dosage is too high.
▶
Immediate measure: mix a tablespoon of fabric
softener with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
▶
When the intelligent dosing is activated, reduce the
basic dosing amount
→ Page 38.
▶
When dosing manually, reduce the amount of
detergent for the next wash with an equal load.
i-Dos
cannot be pressed
i-Dos Intelligent dosing is not possible for this program.
▶
No error - no action required.
→ "Start program with intelligent dosing system",
page 36
52