Faults and what to do about them.
en
39
Filter in the water supply
blocked
1.
Release water pressure in the supply
hose:
a) Turn off the tap.
b) Select any programme (except
q
Rinse/
0
Spin/
p
Empty).
c) Start the programme and leave it
to run for approx. 40 seconds.
d) Switch off the appliance.
e) Pull out the mains plug.
2.
Clean the filters:
a) Disconnect the hose from the
tap.
Clean the filter with a small brush.
b) For standard and Aqua-Secure
models, clean the filter on the
rear of the appliance:
Disconnect the hose from the
rear of the appliance.
Use pliers to remove the filter and
then clean it.
c) Connect the hose and check for
leaks.
3
Faults and what to do
about them.
Faults and what to do about them.
Emergency release
E.g. in the event of a power cut
The programme continues when the
power supply is restored.
However, if the laundry has to be
removed, the washing machine door
can be opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot
detergent solution and laundry.
If possible, leave it to cool down first.
:
Warning
Risk of injury!
Reaching into the drum while it is still
turning may cause hand injuries.
Do not reach into the drum when it is
turning.
Wait until the drum has stopped turning.
:
Warning
Irritation of the respiratory tract!
Any active oxygen that is emitted may
irritate the mucosa and cause eyes to
water.
Do not open the door using the
emergency release if a programme is
running with active oxygen.
Wait until there is no active oxygen in
the drum.
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the washing machine door
if water can be seen through the glass.
1.
Switch off the appliance. Pull out the
mains plug.