Positioning and connecting
en
27
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from testing, run the first wash cycle
without
any laundry.
Note:
The washing machine
must be
correctly
installed
and
connected
. See
~
Page 14
onwards
Preparatory work:
1.
Plug the mains plug into the mains.
2.
Turn on the tap.
Run a programme without laundry:
1.
Switch on the appliance.
2.
Close the door (do not load any
laundry).
3.
Set the
Cottons
90 °C
programme.
4.
Open the detergent drawer.
5.
Pour approximately 1 litre of water
into compartment
II
.
6.
Pour standard washing powder into
compartment
II
.
Note:
To prevent foaming, only use
half the amount of detergent
recommended by the detergent
manufacturer.To prevent foaming,
only use half the amount of
detergent recommended by the
detergent manufacturer. Do not use
detergent designed for woollens or
delicates.
7.
Close the detergent drawer.
8.
Press the
I
button.
9.
Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
